Snow Blowers

Click snowblowers for many different snowblowers sold on Amazon, shipped to your home,

The best time to make sure your snow blower is ready to go for the season is in October or November before it gets really cold. That’s why we are saying Tune Your Snow Blower Engine Now! The picture on the left, covers most of the small engine types. There are some snow blowers at the bottom of the picture. All have similar steps to follow. However obviously each is different. They require specific action for your snow blower to be ready to go for the coming winter. We will go through each of the steps or activities in a bit more detail. Always ensure that there is fresh gasoline in the tank to avoid clogging the carburetor.

Tune Your Snow Blower Engine Now

Inspect The Safety System – check that all levers etc disengage properly, with the engine off check the shear pins, lights work if you have them

Replace or Clean the Spark Plug – replace if in doubt, clean and regap if you reuse the old one.

Click snowblowers for many different snowblowers sold on Amazon, shipped to your home,

Adjust the Skid Shoes if Needed – Check that the bolts are tight and they lift the shave plate slightly above the surface of your driveway

Change the Engine Oil – at minimum once a year in the fall and more often if the engine is used a great deal as per the manufacturers instructions

Adjust the Shave Plate if Needed – it should be slightly above the surface, but not so much that it leaves a significant layer of snow on the driveway

Adjust the Drive System if Needed – check the belts for fraying and cracking, replace as needed and ensure that there is an appropriate amount of tension

Test the Snowblower for Operation.  Start it up and let it run for a few minutes and test all moving parts.

Add Fuel Stabilizer – to the gasoline tank and the extra fuel you keep for refilling. This will ensure that your engine runs smoothly and does not gum up.

Following these steps should ensure that you have a problem free winter. Unless you have missed a major item that needs an overhaul.

You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.