Hard to find instructions: To replace the Auger Drive Belt on the John Deere Snowblowers (827E, 928E, 1028E, 1130SE, 1330SE, 1332PE), Contributed by terry_angers@hotmail.com
1. Lockout ignition so no accidental start (eg remove spark plug wire)
2. Ensure gas tank is closed tightly and fuel is turned off.
3. Raise unit into service position (onto face of auger) so you can remove the bottom plate. Bottom plate is held on with 4 bolts. It is not absolutely required to remove the plate, but it makes it easier to remove old and install new belt.
4. Return unit to normal position
5. Remove the plastic belt cover shroud (black plastic section between ejection Chute and the engine. This is held on with two bolts, one on each side
6. Lock Auger Drive engagement handle into ON position (easily down by using a squeeze clamp to hold it in place or tape / wire / other)
7. Partially separate the main body of the snowblower from the auger housing to allow room to remove / install the belt. There are six bolts securing the two halves. ONLY REMOVE the top two bolts on each side. Then JUST LOOSEN slightly the bottom two bolts. The back half of the snowblower will tilt backwards; the auger housing forwards. You only need to let it tilt a small amount to be able to easily slide the new belt in place.
8. Once belt is around the lower large pulley, reattach the snowblower body securely with all six bolts before finalizing belt onto the small upper pulley.
9. If you have not forgotten to lock the auger drive handle down, it will not be hard to rotate the new belt with some pressure onto the upper pulley. Check that the belt is oriented around the idle pulley in the same manner as the traction belt.
10. The upper “belt guide” rod should be about 1/8” from the belt when the auger drive handle is down. Adjust position if needed by loosening mount bolt.
11. The amount of Deflection the new belt should have is a little more than ½” with moderate pressure.
12. Check the Auger drive cable length adjustment to confirm it is not too tight or has excess slack.
13. Check Pulley alignment to ensure that the idler pulley is in alignment with the upper and lower pulleys. You may need to bend the pulley mount plate a very small amount in either direction to ensure alignment (there is not a direct adjustment) the plate can be pressured with two small lengths of wood (eg 1”x1” x 12”) when brace against the housing
14. Reinstall the Belt cover
15. Reinstall the bottom plate
16. Turn on fuel and enable ignition
17. Start the engine and test that the belts and auger are working properly
The Toro Power Max 826 OHAE Snowthrower, Model 37802, has been recalled due to a…
Everyone wants to be independent and not look for help. However there comes a time…
Should seniors buy a snow blower or should they hire a neighbor to clear the…
Many people ask the question, how to prepare my snowblower ready for winter season and…
As Fall and winter approach, it is time to check your snow blower. Doing maintenance…
The Ariens Deluxe 28 254cc Two-Stage Snow Blower is a large 28 inch wide machine…
View Comments
On STEP 7, a soon as you loosen the lower bolts, the back half will drop to the ground, completely separating the two halves. This will make it difficult to piece them back together in proper alignment. The rear handles must be supported in an upright position.